Alcatel-Lucent 6850-48 ネットワークガイド
Modifying IPMSv6 Parameters
Configuring IP Multicast Switching
page 42-32
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
Configuring the Source Timeout
followed by the new value. For example, to set the source timeout to 360 seconds on the system if no
VLAN is specified, you would enter:
VLAN is specified, you would enter:
-> ipv6 multicast source-timeout 60
You can also modify the source timeout on the specified VLAN by entering:
-> ipv6 multicast vlan 2 source-timeout 60
Restoring the Source Timeout
To restore the source timeout to its default (i.e., 30 seconds) value on the system if no VLAN is specified,
use the
use the
command by entering:
-> ipv6 multicast source-timeout 0
Or, as an alternative, enter:
-> ipv6 multicast source-timeout
To restore the source timeout to its default value.
You can also restore the source timeout on the specified VLAN by entering:
-> ipv6 multicast vlan 2 source-timeout 0
Or, as an alternative, enter:
-> ipv6 multicast vlan 2 source-timeout
To restore the source timeout to its default value.
Enabling and Disabling the MLD Querying
By default MLD querying is disabled.The following subsections describe how to enable and disable MLD
querying by using the
querying by using the
command.
Enabling the MLD Querying
followed by the enable keyword.
For example, to enable the MLD querying you would enter:
-> ipv6 multicast querying enable
You can also enable the MLD querying on the specified VLAN by entering:
-> ipv6 multicast vlan 2 querying enable
Disabling the MLD Querying
You can disable the MLD querying by entering
followed by the disable
keyword. For example, to disable the MLD querying you would enter:
-> ipv6 multicast querying
disable