Alcatel-Lucent 6850-48 Guida Di Rete

Diagnosing Switch Problems

Remote Monitoring (RMON) Overview

OmniSwitch AOS Release 6 Network Configuration Guide

page 45-11

The following table shows Remote Network Monitoring default values.

1 Enable an inactive (or disable an active) RMON probe, where necessary. You can also enable or 
disable all probes of a particular flavor, if desired. For example:

-> rmon probes stats 1011 enable

-> rmon probes history disable

2 To verify the RMON probe configuration, enter the 

show rmon probes 

command, with the keyword 

for the type of probe. For example, to display the statistics probes, enter the following:

-> show rmon probes stats

The display is similar to the one shown below:

Entry  Slot/Port  Flavor    Status      Duration     System Resources

-------+----------+---------+-----------+------------+----------------

1011      1/11    Ethernet  Active      11930:27:05   272 bytes

3 To view statistics for a particular RMON probe, enter the show rmon probes command, with the 
keyword for the type of probe, followed by the entry number for the desired RMON probe. For example:

-> show rmon probes 1011

The display will appear similar to the one shown below:

Probe's Owner: Switch Auto Probe on Slot 1, Port 11

Entry  1011

Flavor = Ethernet, Status = Active,

Time = 11930 hrs 26 mins,

System Resources (bytes) = 272

For more information about these commands, see 

, 

, or the

 

“RMON Commands” chapter 

in the OmniSwitch CLI Reference Guide.

RMON Probe Configuration

No RMON probes configured.