Alcatel-Lucent 6850-48 Guida Di Riferimento
Health Monitoring Commands
page 50-2
OmniSwitch CLI Reference Guide
September 2009
health threshold
Configures thresholds for input traffic (RX), output/input traffic (TX/RX), memory usage, CPU usage, and
chassis temperature.
chassis temperature.
Input traffic, output/input traffic, memory usage, and CPU usage thresholds specify the maximum percent-
age for each resource that may be consumed before a trap is sent to the user. The temperature threshold
specifies the maximum operating temperature, in Celsius, allowed within the chassis before a trap is sent.
age for each resource that may be consumed before a trap is sent to the user. The temperature threshold
specifies the maximum operating temperature, in Celsius, allowed within the chassis before a trap is sent.
health threshold {rx percent | txrx percent | memory percent | cpu percent | temperature degrees}
Syntax Definitions
rx
Specifies the maximum input (RX) traffic threshold.
txrx
Specifies the maximum output/input (TX/RX) traffic threshold.
memory
Specifies the maximum RAM memory usage threshold.
cpu
Specifies the maximum CPU usage threshold.
percent
The new threshold value, in percent, for the corresponding resource—
i.e., rx, txrx, memory, cpu—(0–100).
i.e., rx, txrx, memory, cpu—(0–100).
temperature
Specifies the temperature threshold for the chassis.
degrees
The new threshold value, in Celsius, for the chassis temperature
threshold (0–100).
threshold (0–100).
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• When a resource falls back below the configured threshold, an additional trap is sent to the user. This
indicates that the resource is no longer operating beyond its configured threshold limit.
• Changing a threshold value sets the value for all levels of the switch (i.e., switch, module, and port).
You cannot set different threshold values for each level.
, or refer to the “Diagnosing Switch
Problems” chapter in the OmniSwitch AOS Release 6 Network Configuration Guide.
command. Do not use the
command as it does not display health threshold statistics. These two show
commands are unrelated.
parameter
default
percentage
80
degrees
50