Alcatel-Lucent 6850-48 Guida Di Riferimento
QoS Policy Commands
OmniSwitch CLI Reference Guide
September 2009
page 53-53
policy condition source network group
Associates a source network group with a policy condition.
policy condition condition_name source network group network_group
policy condition condition_name no source network group
Syntax Definitions
condition_name
The name of the condition.
network_group
The name of the source network group. Network groups are configured
through the policy network group command. See
through the policy network group command. See
for more
information about this command.
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Use the no form of the command to remove a source network group from a condition; however, at least
one classification parameter must be associated with a condition.
• A source IP address and a source IP network group cannot be specified in the same condition.
Examples
-> policy condition cond5 source network group webgroup1
Release History
Release 6.1; command was introduced.
Related Commands
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Configures a network group name and its associated IP addresses.
Shows information about policy conditions configured on the switch.
Displays information about policy network groups.