Alcatel-Lucent 6850-48 Guida Di Riferimento

QoS Policy Commands

OmniSwitch CLI Reference Guide

page 53-55

Associates a destination network group with a policy condition.

policy condition condition_name destination network group network_group

policy condition condition_name no destination network group

The name of the condition.

The name of the destination network group. Network groups are config-
ured through the policy network group command. See 

more information about this command.

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of the command to remove a destination network group from a condition; however, at 

least one classification parameter must be associated with a condition.

• A destination IP address and a destination IP network group cannot be specified in the same condition.

-> policy condition cond6 destination network group webgroup1

Release 6.1; command was introduced.

Creates a policy condition.

Configures a network group name and its associated IP addresses. 

Applies configured QoS and policy settings to the current configuration. 

Shows information about policy conditions configured on the switch.

Displays information about policy network groups.