Printronix SL4M Manuale Utente
SENSOR SETUP Submenus
89
Online Auto-Cal
NOTE: Online Auto-Cal will not function when there is data in the the buffer
and when Error Recover (in MEDIA SETUP menu) is enabled
(see page 69).
(see page 69).
The options for Online Auto-Cal are:
•
Disable (factory default).
•
Enable. Whenever the printer is brought online, it automatically performs
an Run Auto-Cal (see “Run Auto-Cal (Auto-Calibrate)” on page 86). Once
the Run Auto- Cal is complete, the printer momentarily displays the
Sensed Distance determined by the Auto Calibrate and then resumes
printing any pending jobs.
an Run Auto-Cal (see “Run Auto-Cal (Auto-Calibrate)” on page 86). Once
the Run Auto- Cal is complete, the printer momentarily displays the
Sensed Distance determined by the Auto Calibrate and then resumes
printing any pending jobs.
Gap Windowing
This feature compensates for any early falling edges or spurious peaks and
troughs that may appear within the gap length in media. These edges or
peaks and troughs can cause unreliable detection of the leading edge of the
next label (top-of-form). Use Gap Windowing to resolve the following
problems:
troughs that may appear within the gap length in media. These edges or
peaks and troughs can cause unreliable detection of the leading edge of the
next label (top-of-form). Use Gap Windowing to resolve the following
problems:
•
Loss of one or more complete (serialized) labels.
•
Start of an image printed in the middle of a gap, especially with fanfold,
perforated media.
perforated media.
•
Top part of an image lost when printing in head-first orientation.
The options for Gap Windowing are Disable and Enable:
•
Disable (factory default). When the leading edge of a gap is detected, the
printer continuously looks for the leading edge of the next label and uses
it as the TOF position. Perforations or unusual media discrepancies within
the gap can cause inaccurate TOF detection.
printer continuously looks for the leading edge of the next label and uses
it as the TOF position. Perforations or unusual media discrepancies within
the gap can cause inaccurate TOF detection.
•
Enable. When the leading edge of a gap is detected, the printer ignores
the first 90% of the gap length value specified in the Gap Length menu
option. The result is that cross perforations or unusual media
discrepancies within the gap are filtered out, allowing the printer to
reliably detect the actual leading edge of the next label and use it as the
TOF position.
the first 90% of the gap length value specified in the Gap Length menu
option. The result is that cross perforations or unusual media
discrepancies within the gap are filtered out, allowing the printer to
reliably detect the actual leading edge of the next label and use it as the
TOF position.
Gap Length
Gap Length is the actual length (height) of a label gap measured in .01 inch
increments. The range is 0.05 to 1.00 inches.
increments. The range is 0.05 to 1.00 inches.
NOTE: You must enter the correct Gap Length. If the Gap Length is too long,
the image will shift down from the leading edge (TOF) of the label.
The factory default is 0.12 inches.