Netgear gsm7312 Manuale Utente

8-12

Routing Commands

A number which represents the metric used for default routes in RIP updates 

originated on the specified interface. This is a configured value.

The following information will be invalid if the link state is down.

The number of RIP response packets received by the RIP process which were 

subsequently discarded for any reason.

The number of routes contained in valid RIP packets that were ignored for any 

reason.

The number of triggered RIP updates actually sent on this interface.

This command displays general information for each RIP interface. For this command to display 
successful results routing must be enable per interface (i.e. config router rip interface <slot.port> 
enable). 

The unit slot.port identifying each interface.

The IP source address used by the specified RIP interface.

The RIP version(s) used when sending updates on the specified interface. The 

types are none, RIP-1, RIP-1c, RIP-2.

The RIP version(s) allowed when receiving updates from the specified interface. 

The types are none, RIP-1, RIP-2, Both 

RIP administrative mode of router RIP operation; enable activates, disable de-

activates it.

The mode of the interface (up or down).

This command sets the administrative mode of RIP in the router to active or inactive. 

disable

This command sets the route preference value of RIP in the router. Lower route preference values 
are preferred when determining the best route.

15