Netgear gsm7312 Manuale Utente

Switching Commands

7-25

The physical slot and physical port.

If not blank, this field indicates that this port is a special type of port. The 
possible values are: 
Mon - this port is a monitoring port. Look at the Port Monitoring screens to find 
out more information. 
Lag - this port is a member of a Lag. Look at the Lag screens to find out more 
information. 
Probe - this port is a probe port. Look at the Port Mirroring screens to find out 
more information.

Selects the Port control administration state. The port must be enabled in order 
for it to be allowed into the network. - May be enabled or disabled by selecting 
the corresponding line on the pull-down entry field. The factory default is 
enabled. 

Selects the desired port speed and duplex mode. If auto-negotiation support is 
selected, then the duplex mode and speed will be set from the auto-negotiation 
process. Note that the port's maximum capability (full duplex -100M) will be 
advertised. Otherwise, this object will determine the port's duplex mode and 
transmission rate. The factory default is Auto. 

Indicates the port speed and duplex mode. 

Indicates whether the Link is up or down. 

This object determines whether or not to send a trap when link status changes. 
The factory default is enabled. 

Displays whether LACP is enabled or disabled on this port.

This command enables or disables a port.

enable

This command enables or disables flow control on the specified interface.