Adtran 3458-poe Manuale Hardware
Physical Descriptions
NetVanta 3000 Series Hardware Installation Guide
34
Copyright © 2010 ADTRAN, Inc.
61200860L1-34AA
Figure 14. NetVanta 3305 Front Panel Layout
NetVanta 3305 Rear Panel Design
The NetVanta 3305 rear panel is shown below with modules installed.
provides
pinouts.
Figure 15. NetVanta 3305 Rear Panel Layout
NetVanta 3305 Rear Panel Interfaces and LEDs
NET/DBU Option Slots
The
SLOT x NET/DBU
option slots support various NIM plug-in option modules. These option
modules are described in the section
10/100Base-T Ethernet Interface and Activity LEDs
The Ethernet ports (
ETH 0/1
and
ETH 0/2
) are RJ-45 connectors with LEDs. The amber activity LED
flashes when data traffic is being sent or received on the Ethernet port. The green link LED is on when
the router has a good connection to the LAN. The Ethernet port provides the following:
the router has a good connection to the LAN. The Ethernet port provides the following:
•
10Base-T or 100Base-T with a single connector
•
Auto-negotiation
•
CSMA/CD
•
IEEE 802.3 compatibility
CONSOLE Interface
The
CONSOLE
interface is an EIA-232 serial port (DCE) that provides for local management and
configuration (via a DB-9 female connector).
Power Connection
The rear panel has a power input for connection to the power supply. Power supplies are shipped with
final destinations in mind. For example, domestic routers are shipped with a wallmount supply and
international routers are shipped with a universal input lump-in-line supply with the appropriate
cables. All of the 1U-high products have universal power supplies and are shipped with the appropriate
cable. Please refer to
final destinations in mind. For example, domestic routers are shipped with a wallmount supply and
international routers are shipped with a universal input lump-in-line supply with the appropriate
cables. All of the 1U-high products have universal power supplies and are shipped with the appropriate
cable. Please refer to
for connection details.
Connection directly to an external modem requires a cross-over cable.
SLOT 1 NET/DBU
SLOT 2 NET/DBU
WAN-T1
DSX-1
DBU
WAN-T1
DSX-1
DBU
ETH 0/1
ETH 0/2
100-250VAC
50/60Hz