Adtran 3458-poe Manuale Hardware
Unit Installation
NetVanta 3000 Series Hardware Installation Guide
82
Copyright © 2010 ADTRAN, Inc.
61200860L1-34AA
Wall Mounting the NetVanta PoE Power Supply
The NetVanta PoE Power Supply can be wall mounted. Follow these steps to wallmount the
NetVanta PoE Power Supply:
NetVanta PoE Power Supply:
Instructions for Wall Mounting the NetVanta PoE Power Supply
Step
Action
1
Decide on a location for the power supply. Keep in mind that the power supply needs to be mounted close
enough to the NetVanta unit for the cords to reach the receptacles.
enough to the NetVanta unit for the cords to reach the receptacles.
2
Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick) to a wall
stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide sufficient long-
term stability.
stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide sufficient long-
term stability.
3
Install two #8 PAN head screws (1-inch or greater in length) into the mounted board, following these
guidelines and referring to
guidelines and referring to
•
Mark the exact positioning of the screws by using the keyhole slots on the sides of the unit as a
template.
template.
•
Screws should be horizontally level with each other.
•
Leave approximately 1/4-inch of the screws protruding from the board to allow the heads of the screws
to slide into place in the unit’s keyhole slots.
to slide into place in the unit’s keyhole slots.
4
Insert the screws through the keyhole slots in both sides of the unit and slide the slot securely onto the
screws.
screws.
5
.
The NetVanta PoE power supply and the NetVanta base unit with which it is
associated both should be installed in a restricted access location as described in
UL 60950-1, first edition.
associated both should be installed in a restricted access location as described in
UL 60950-1, first edition.
Under full load, the NetVanta PoE power supply may be hot to the touch.