Netopia 2e-w Guida Utente
Cayman 2E-W User’s Guide
Diagnostic Console
November 2000
B-7
revert
The
revert
command retrieves the saved version of settings from
non-volatile storage and overwrites any changes made since the last
save.
save.
save
The
save
command saves the EPROM settings you have entered or
changed to non-volatile storage in the Cayman 2E-W.
show
The
show
command displays the current EPROM settings for the
Cayman 2E-W and a brief explanation of those settings. For example,
the show command produces the following:
the show command produces the following:
BootPROM> show
flash on
(flash will be tried)
ip 0
(no ip address; tftp will not be tried)
file <unset>
(must be set for tftp download)
bootp on
(will attempt configuration via bootp)
autoboot 10
(will autoboot on powerup, and will try
10 times)
autoprog never
(will never program a downloaded
image into flash)
Cayman 2E-W serial no. 800700, h/w rev. 1, eprom v1.3
Last install status: code flash successfully programmed
flash image 1: Cayman 2E-W 5.3.0
Boot Setting
Commands
Commands
The following commands specify boot settings for the Cayman 2E-W.
autoboot { retry_count | off }
The
autoboot
retry_count
command (where
retry_count
is any
whole number) sets the number of times the Cayman 2E-W should
attempt to start an image and run it when powered up. If you enable
autoboot with the
attempt to start an image and run it when powered up. If you enable
autoboot with the
autoboot retry_count
command, the autoboot