Quantum atl 7100 Guida Utente
Chapter 2 Operating the Library
Operating Procedures
Operating Procedures
22
Quantum|ATL 7100 Series Library Operator’s Guide
5
When finished, close the storage array door.
6
Press the control panel
STANDBY
button, and verify that
System On-line is displayed in the SDA.
Turning the
Interior Light On
or Off
Interior Light On
or Off
2
The library is normally shipped with the interior light set to the On
position. Use the following procedure to turn the interior light on
or off.
position. Use the following procedure to turn the interior light on
or off.
1
Press the control panel
STANDBY
button. The library robotics
will stop after completing the current command(s). Verify that
System Off-line is displayed in the SDA.
System Off-line is displayed in the SDA.
2
Open the front door by pulling the door towards you. (The
door opens to your right.)
door opens to your right.)
3
Reach through the front door and set the light switch on the far
side of the light to the desired position (see
side of the light to the desired position (see
).
4
Close and latch the library front door.
5
Press the control panel
STANDBY
button, and verify that
System On-line is displayed in the SDA.
Note:
The load port bins are keyed to ensure that tape
cartridges are inserted in the proper orientation.
Fixed storage array bins inside the library, however,
are not keyed, and you MUST ensure that cartridges
are loaded in the proper orientation.
cartridges are inserted in the proper orientation.
Fixed storage array bins inside the library, however,
are not keyed, and you MUST ensure that cartridges
are loaded in the proper orientation.
Note:
The interior light bulb is not an operator-replaceable
item. If the light bulb needs replacement, notify your
field service engineer.
item. If the light bulb needs replacement, notify your
field service engineer.