Quantum DLT-V4 Guida Utente
Chapter 3 Installing the Internal SATA Tape Drive
Installation Steps
DLT-V4 Product Manual
17
Installation Steps
3
To install the tape drive, perform the following tasks in this order. Follow
the detailed instructions on the pages listed below.
Table 3 Installing the DLT-V4
Internal SATA Tape Drive
Internal SATA Tape Drive
Unpacking the Internal SATA Tape Drive
3
Before you do anything else, unpack and inspect the tape drive for
shipping damage. If you notice any damage, report it both to the sales
representative and to the shipping company immediately.
If there is no damage to the tape drive, select a server or workstation to
host the tape drive, then move on to the following installation steps.
Step
Instruction
Page
1
Unpack and check the tape drive for shipping
damage.
2
Select a server or workstation to host the tape
drive.
3
Download and install the current device
driver (if required) (see
4
Install the tape drive in the server or
workstation. Connect all the cables and secure
the tape drive in the system.
5
Confirm the installation.
Note:
Save the packing materials in case you need to move or ship
the tape drive in the future. You must ship the tape drive in
the original (or equivalent) packing materials or you will
invalidate the warranty.