Quantum DLT-V4 Guida Utente
Chapter 9 Using Data and Cleaning Cartridges
Using the Cleaning Cartridge
DLT-V4 Product Manual
63
Using the Cleaning Cartridge
9
When the
Clean
LED is illuminated, your tape drive’s read/write head
needs to be cleaned.
Use only approved cleaning cartridges in your DLT-V4 tape drive. Use of
any other type of cleaning cartridge can damage the read/write head in
your tape drive.
Figure 27 DLT VS1 Cleaning
Cartridge
Cartridge
Each cleaning cartridge has a useful life of 20 cleanings. The cleaning
cartridge includes a label with 20 small boxes printed on it. Place a check
mark in one of the boxes each time you use the cleaning cartridge to clean
the tape drive. Replace the cleaning cartridge when you have checked all
boxes.
When the cleaning cartridge has cleaned the read/write head, the
When the cleaning cartridge has cleaned the read/write head, the
Clean
LED turns off and the tape drive ejects the cleaning cartridge.
Caution:
Follow the instructions as detailed in
on page 59 to load the cleaning cartridge. The
DLT-V4 tape drive will accept only a DLT VS1 cleaning
cartridge. Cleaning typically takes several minutes, during
which the
Clean
LED blinks. If you attempt to load an
inappropriate type of cleaning cartridge, your DLT-V4
tape drive prevents damage by ejecting the cartridge after
approximately 25 seconds without allowing the cleaning
tape to come into contact with the read/write head.