Sony STR-DA5600ES Guida Utente
47
GB
G
e
tting Star
te
d
10: Calibrating the
appropriate speaker
settings automatically
appropriate speaker
settings automatically
(Auto Calibration)
The DCAC (Digital Cinema Auto Calibration)
function allows you to perform automatic
calibration, such as checking the connection
between each speaker and the receiver,
adjusting the speaker level, and measuring the
distance of each speaker from your seating
position automatically.
function allows you to perform automatic
calibration, such as checking the connection
between each speaker and the receiver,
adjusting the speaker level, and measuring the
distance of each speaker from your seating
position automatically.
• Set up and connect the speakers (page 21-
24).
• The AUTO CAL MIC jack is used for the
supplied optimizer microphone only. Do not
connect other microphones. Doing so may
damage the receiver and the microphone.
connect other microphones. Doing so may
damage the receiver and the microphone.
• During the measurement, the sound that
comes out of the speakers is very loud. The
volume of the sound cannot be adjusted. Pay
attention to the presence of children or to the
effect on your neighborhood.
volume of the sound cannot be adjusted. Pay
attention to the presence of children or to the
effect on your neighborhood.
• Perform the measurement in a quiet
environment to avoid the effect of noise and
get a more accurate measurement.
get a more accurate measurement.
• If there are any obstacles in the path between
the optimizer microphone and the speakers,
the calibration cannot be performed
correctly. Remove any obstacle from the
measurement area to avoid measurement
error.
the calibration cannot be performed
correctly. Remove any obstacle from the
measurement area to avoid measurement
error.
Notes
• In the following situations, the measurements have
not been performed correctly or auto calibration
cannot be performed.
– When headphones are connected.
– When connecting special speakers, such as
cannot be performed.
– When headphones are connected.
– When connecting special speakers, such as
dipole speakers.
– When using the zone 2/zone 3 function in zone
2/zone 3.
• Cancel MUTING if it is set to on.
1
Select the speaker pattern
(page 44).
(page 44).
If you connect front high speakers, select
the speaker pattern that has front high
speakers (5/x.x or 4/x.x) each time
you perform auto calibration. Otherwise,
the characteristics of the front high
speakers cannot be measured.
However, even if you perform auto
calibration with a speaker pattern such as
5/2.x or 4/2.x, when surround back
speakers or a subwoofer are (is)
connected to the receiver, the speaker
pattern is set automatically so that all the
detected speakers are utilized (e.g., 5/4.1,
etc.). If you change the number of
speakers you want to use, reselect the
desired speaker pattern manually after
auto calibration.
Then, you can restore the speaker pattern
that has surround back speakers or a
subwoofer such as 5/4.x, as the
measurement value for those speakers is
stored in the receiver.
the speaker pattern that has front high
speakers (5/x.x or 4/x.x) each time
you perform auto calibration. Otherwise,
the characteristics of the front high
speakers cannot be measured.
However, even if you perform auto
calibration with a speaker pattern such as
5/2.x or 4/2.x, when surround back
speakers or a subwoofer are (is)
connected to the receiver, the speaker
pattern is set automatically so that all the
detected speakers are utilized (e.g., 5/4.1,
etc.). If you change the number of
speakers you want to use, reselect the
desired speaker pattern manually after
auto calibration.
Then, you can restore the speaker pattern
that has surround back speakers or a
subwoofer such as 5/4.x, as the
measurement value for those speakers is
stored in the receiver.
Before you perform auto
calibration
calibration
Optimizer microphone
continued