Klipsch ca-650-t Istruzione Sull'Installazione

Mechanical Installation Drawings for KPT-Jubilee™

Please refer to the following drawings for assembly details: 
Figures 5 and 6:

After unpacking all the components, locate the two

1

/

4

" -20 screws on

top of the KPT-XII. Remove the two screws and washers. Place the KPT-
904-HF unit on top of the KPT-XII, making sure that the hole/slot as
indicated by "A" in Fig. 5 lines up with the holes in the KPT-XII.
Reinstall the screws and washers. Adjust the horizontal angle as desired
and tighten screws. 

Locate the 

1

/

4

" -20 bolts/nuts on both sides of the bracket as shown at

"B" in Fig. 5. To adjust the vertical angle, loosen the bolts and nuts, and
adjust the horn until the desired vertical angle is achieved. Tighten
bolts and nuts.

Please refer to the following drawings for assembly details: 
Figures 7 and 8.

After unpacking all components, locate the KPT-941-T compression
driver and horn. Attach the driver to the horn using supplied hardware.

Locate the two

1

/

4

" -20 screws on top of the KPT-904/940-LF. Remove

the two screws and washers. Place the KPT-941-T-HF unit on top of the
KPT-904/940-LF, making sure that the hole/slot as indicated by "A" in
Fig. 7 lines up with the holes in the KPT-904/940-LF. Reinstall the
screws and washers. Adjust the horizontal angle as desired and tighten
the screws. 

Locate the 

1

/

4

" -20 nuts as shown at "C" in Fig. 7. To adjust the vertical

angle, loosen the nuts and adjust the horn until the desired vertical
angle is achieved. Tighten the nuts.

Mechanical Installation Drawings for KPT-941-T

Fig. 5

Fig. 6

Fig. 7

Fig. 8