Rollei Dk4010 Guida Utente

Contents (Top page) Detailed Contents

Troubleshooting

Problems and Solutions

Problem

Cause

Solution

Nothing appears on 
the LCD monitor.

The batteries are flat or not inserted.

Load unused or charged batteries into 
the camera.

The Power Save function has turned 
the camera off. (Æ p.153)

Press the POWER button 

H again 

to turn the camera back on.

The LCD monitor is 
blank.

EVF (electronic viewfinder) is 
selected in the [SELECT LCD] 
setting.

Press the VF button 

V to select 

the [LCD] monitor display.

If you leave the camera for a while 
without using it, the camera goes into 
Sleep mode.

Press the shutter release button half 
way or press any other camera button to 
restore the camera to Shooting mode. 
The details vary depending on the 
Power Save function settings. (Æ p.153)

There is something generating a 
magnetic field (such as a magnet or 
TV) close to the camera.

Move the camera further away from 
the magnetic object.

The video cable is connected to the 
camera.

Disconnect the video cable.

There's no image 
on the TV.

You are using the wrong video output 
format.

Use the correct video output format for 
the TV. (Æ p.164)

The number of 
available shots did 
not change when I 
took a picture.

This is because the photographed 
image size was small.

This is dependent on factors such as 
the quality mode and the subject and 
is not a problem.

I cannot erase an 
image. "U" icon 
displayed.

The image is protected.

Unprotect the image. (Æ p.108)

The number of 
available shots did 
not increase after I 
erased an image.

This is because the erased image 
size was small.

This is dependent on factors such as 
the quality mode and the subject and 
is not a problem.

The camera feels 
hot.

Because the LCD monitor uses 
relatively large amounts of current, 
the camera grows warm after 
prolonged use.

This is not a problem, but you should 
shut the camera down for a few 
minutes.