Marantz AV8003 Guida Utente

Pagina di 92
ENGLISH
4
OPERATION OF REMOTE CONTROLLER
REMOTE CONTROL
Operate the remote controller within a distance of 
approx. 5m from the infrared receptor window on the 
front of the unit. 
Remote controller
60°
Appro
x. 5 m
Caution:
•  Do not allow direct sunlight, an inverter fl uorescent 
light or other strong source of light to shine onto 
the unit’s infrared receptor window.  Otherwise, 
the operation of the remote controller may be 
disabled.
•  Bear in mind that operating the remote controller 
may cause other devices operated by infrared rays 
to be operated by mistake.
•  The remote controller cannot be operated if 
the space between the controller and the unit’s 
infrared receptor window is obstructed.
•  Do not place any objects on top of the remote 
controller.  
  Doing so may cause one or more buttons to be 
held down which will cause the batteries to run 
down.
LOADING BATTERIES
Before using the remote controller for the fi rst  time, 
load the batteries in the remote controller.  The 
batteries provided are used to verify the operations 
of the remote controller only.
<RC2001>
 
1.
  Remove the back cover.
 
2.
  Insert the new alkaline batteries (AAA type) 
with correct 
ª and · polarity.
 
3.
  Close the battery cover until it clicks shut.
Notes: 
•  Under normal usage, alkaline batteries last 
approximately 3 months.
  The battery life varies depending on the frequency 
of use and the remote controller settings. Frequent 
use will wear down the batteries quicker. 
  Rechargeable batteries can also be used. In this 
case, be sure to use only AAA type NiMH (Nickel 
Metal Hydride) rechargeable batteries. When 
using rechargeable batteries, be sure to follow 
manufacturer guidelines for safety and proper 
usage.
•  When the batteries are almost worn out, “LOW” is 
displayed on the LCD battery indicator.
•  The settings remain saved in the remote controller 
even if the power completely runs out. However, 
the time setting will be lost, and so please set the 
time setting again.
<RC101>
 
1.
  Remove the battery cover.
 
2.
  Insert the new batteries (AAA type) with correct 
ª and · polarity.
 
3.
  Close the battery cover until it clicks shut.
Note: 
•  The life of the batteries used with the remote 
controller is about 4 months with normal use.
CAUTIONS ON BATTERIES
•  Use “AAA” type batteries in this remote controller.
•  We recommend that you use alkali batteries.
•  If the remote controller does not operate from 
close to the unit, replace the batteries with new 
ones, even if less then a year has passed.
•  The included battery is only for verifying operation. 
Replace it with a new battery as soon as possible.
•  When inserting the batteries, be careful to do so in 
the proper direction, following the + and - marks in 
the remote controller’s battery compartment.
•  To prevent damage or battery fl uid leakage:
-  Do not use a new battery with an old one.
-  Do not use two different types of batteries.
-  Do not short-circuit, disassemble, heat or 
dispose of batteries in fl ames.
•  Remove the batteries when not planning to use the 
remote controller for a long period of time.
•  If the batteries should leak, carefully wipe off the 
fl uid from the inside of the battery compartment, 
then insert new batteries.
•  When disposing of used batteries, please comply 
with governmental regulations or environmental 
public instruction’s rules that apply in your country 
or area.
AV8003N.indb   4
AV8003N.indb   4
08.4.28   10:49:10 AM
08.4.28   10:49:10 AM