Gigaset C380 S30852-H2007-K101 Manuale Utente
Codici prodotto
S30852-H2007-K101
43
Service (Customer Care)
C380 / IM-NORD EN / A31008-M2007-R201-1-SM19 / appendix.fm / 18.10.2008
Ve
rs
ion 4,
29
.10.
2007
Questions and answers
If you have any questions about using
your phone, visit us at www.gigaset.com/
customercare at any time. The table
below contains a list of common problems
and possible solutions.
Authorisation
This device is intended for analogue
phone lines in your network.
Country-specific requirements have been
Country-specific requirements have been
taken into consideration.
We, Gigaset Communications GmbH,
We, Gigaset Communications GmbH,
declare that this device meets the
essential requirements and other relevant
regulations laid down in Directive 1999/5/
EC.
A copy of the 1999/5/EC Declaration of
A copy of the 1999/5/EC Declaration of
Conformity is available at this Internet
address:
The display is blank.
1. The handset is not switched on.
1. The handset is not switched on.
¥
Press and hold the end call key
a
.
2. The batteries are flat.
Charge or replace the batteries
"
Base
" flashes in the display.
1. The handset is outside the range of the
base station.
¥
Move the handset closer to the base
station.
The base station's range is reduced
because Eco Mode mode is activated.
¥
Deactivate Eco Mode (
reduce the distance between the hand-
set and base station.
3. The base station is not turned on.
Check the base station's mains adapter
Handset does not ring.
1. The ringer is deactivated.
1. The ringer is deactivated.
¥
Activate the ringer (
You cannot hear a ringer/dialling tone from
the fixed line network.
The phone cord supplied has not been used or
The phone cord supplied has not been used or
has been replaced by a new cord with the
wrong pin connections.
¥
Please always use the phone cord supplied
or ensure that the pin connections are cor-
rect when purchasing from a retailer
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
You have entered the wrong system PIN.
Reset the system PIN to 0000
Forgotten the system PIN.
Reset the system PIN to 0000
The other party cannot hear you.
You have pressed the
You have pressed the
§Mute§
display key.
The handset is "muted".
Activate the microphone again
The number of the caller is not displayed
despite CLIP.
Calling Line Identification is not enabled.
Calling Line Identification is not enabled.
¥
The caller should ask the network provider
to release Calling Line Identification (CLI).
You hear an error tone (descending tone
sequence) when inputting.
Action has failed/invalid input.
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user
Watch the display and refer to the user
guide if necessary.
You cannot listen to messages on the
network mailbox.
Your PABX is set for dial pulsing.
Your PABX is set for dial pulsing.
¥
Set your PABX to touch tone dialling.