EchoStar t-105 Guida Utente

© 2

004

 Ec

h

o

S

ta

r I

n

te

rn

at

io

na
l 

Co
rp

or

a

tio

n

A

ll ri
gh
ts

 re
serve

d

1. No picture or sound 

in the TV or radio 
mode.

■

Receiver is in 
standby.

■

Switch the receiver 
on.

■

Cable related 
problems.

■

Check the cable 
connections.

■

aerial related 
problems.

■

Make sure the aerial 
is correctly aimed. 

2. Bad picture or noisy 

sound in the TV or 
radio mode.

■

Bad reception of the 
signal.

■

Make sure the aerial 
is clean, in good 
condition and 
correctly aimed. 

■

Contact your service 
provider if your area 
has sufficient signal.

■

Poor or bad weather 
conditions.

■

There is no solution 
for this. 

■

You might consider 
to get a better aerial 
installation.

3. My television does 

not give any audio.

■

The MUTE option is 
active.

■

On the RCU, press 
the mute key once.

■

The volume is set to 
minimum.

■

On the RCU, press 
the V+ key.

4. There is no Dolby 

Digital (AC-3) 
sound to my other 
equipment.

■

The equipment is 
connected to the 
receiver with a RCA 
or SCART cable only.

■

Connect the 
S/PDIF connector of 
the receiver to the 
Dolby Digital input of 
the Dolby Digital 
amplifier.

■

The Dolby Digital 
option is not set to 
On.

■

Press the menu key.

■

Select Installation - 
System setup - 
connection - SPDIF 
output, to set the 
Dolby Digital option 
to Enable.

5. There is no audio 

while I watch a 
Dolby Digital 
program.

■

The Dolby Digital 
amplifier is set to Off.

■

Set the Dolby Digital 
amplifier to On.

■

The receiver is not 
connected to a Dolby 
Digital amplifier.

■

Press the menu key.

■

Select Installation - 
System setup - 
connection - SPDIF 
output, to set the 
Dolby Digital option 
to Disable.

6. Nothing helps.

■

-

■

Set the receiver to 
standby and pull the 
electrical power plug.

■

Re-insert the 
electrical power plug.

■

Do a factory reset. 
Please refer to the 
applicable paragraph 
for detailed 
instructions.