EchoStar t-105 사용자 가이드
Page 3 - 2
EchoStar International Corporation
© 2
004
Ec
h
o
S
ta
r I
n
te
rn
at
io
na
l
l
Co
rp
rp
or
a
tio
n
A
ll ri
gh
ts
gh
ts
re
serve
serve
d
5.
TV
AND
R
ADIO
RELATED
Problem
Possible cause
What to do?
1. No picture or sound
in the TV or radio
mode.
mode.
■
Receiver is in
standby.
standby.
■
Switch the receiver
on.
on.
■
Cable related
problems.
problems.
■
Check the cable
connections.
connections.
■
aerial related
problems.
problems.
■
Make sure the aerial
is correctly aimed.
is correctly aimed.
2. Bad picture or noisy
sound in the TV or
radio mode.
radio mode.
■
Bad reception of the
signal.
signal.
■
Make sure the aerial
is clean, in good
condition and
correctly aimed.
is clean, in good
condition and
correctly aimed.
■
Contact your service
provider if your area
has sufficient signal.
provider if your area
has sufficient signal.
■
Poor or bad weather
conditions.
conditions.
■
There is no solution
for this.
for this.
■
You might consider
to get a better aerial
installation.
to get a better aerial
installation.
3. My television does
not give any audio.
■
The MUTE option is
active.
active.
■
On the RCU, press
the mute key once.
the mute key once.
■
The volume is set to
minimum.
minimum.
■
On the RCU, press
the V+ key.
the V+ key.
4. There is no Dolby
Digital (AC-3)
sound to my other
equipment.
sound to my other
equipment.
■
The equipment is
connected to the
receiver with a RCA
or SCART cable only.
connected to the
receiver with a RCA
or SCART cable only.
■
Connect the
S/PDIF connector of
the receiver to the
Dolby Digital input of
the Dolby Digital
amplifier.
S/PDIF connector of
the receiver to the
Dolby Digital input of
the Dolby Digital
amplifier.
■
The Dolby Digital
option is not set to
On.
option is not set to
On.
■
Press the menu key.
■
Select Installation -
System setup -
connection - SPDIF
output, to set the
Dolby Digital option
to Enable.
System setup -
connection - SPDIF
output, to set the
Dolby Digital option
to Enable.
5. There is no audio
while I watch a
Dolby Digital
program.
Dolby Digital
program.
■
The Dolby Digital
amplifier is set to Off.
amplifier is set to Off.
■
Set the Dolby Digital
amplifier to On.
amplifier to On.
■
The receiver is not
connected to a Dolby
Digital amplifier.
connected to a Dolby
Digital amplifier.
■
Press the menu key.
■
Select Installation -
System setup -
connection - SPDIF
output, to set the
Dolby Digital option
to Disable.
System setup -
connection - SPDIF
output, to set the
Dolby Digital option
to Disable.
6. Nothing helps.
■
-
■
Set the receiver to
standby and pull the
electrical power plug.
standby and pull the
electrical power plug.
■
Re-insert the
electrical power plug.
electrical power plug.
■
Do a factory reset.
Please refer to the
applicable paragraph
for detailed
instructions.
Please refer to the
applicable paragraph
for detailed
instructions.
Problem
Possible cause
What to do?