ZyXEL ES-3148 Guida Utente
Chapter 5 Initial Setup Example
ES-3148 User’s Guide
64
2 In the Static VLAN screen, select
ACTIVE, enter a descriptive
name in the Name field, and enter
2 in the VLAN Group ID field for
the VLAN2 network.
name in the Name field, and enter
2 in the VLAN Group ID field for
the VLAN2 network.
"
The VLAN Group ID field in this screen and the VID field in the IP Setup
screen refer to the same VLAN ID.
screen refer to the same VLAN ID.
3 Since the VLAN2 network is connected to port 1 on the Switch, select Fixed to
configure port 1 to be a permanent member of the VLAN only.
4 To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames
properly, clear the TX Tagging check box to set the Switch to remove VLAN tags
before sending.
before sending.
5 Click Add to save the settings to the run-time memory. Settings in the run-time memory
are lost when the Switch’s power is turned off.
5.1.2 Setting Port VID
Use PVID to add a tag to incoming untagged frames received on that port so that the frames
are forwarded to the VLAN group that the tag defines. In the example network, configure 2 as
the port VID on port 1 so that any untagged frames received on that port get sent to VLAN 2.
are forwarded to the VLAN group that the tag defines. In the example network, configure 2 as
the port VID on port 1 so that any untagged frames received on that port get sent to VLAN 2.
Figure 21 Initial Setup Network Example: Port VID
exa
m
pl
e