Luxeon D315M Guida Utente



 Digital Projector User’s Guide 

The power and lamp indicator on the control pad provides you with information about the 
condition of the projector. 

Indicator  Light Status 

Condition 

Lamp 

Ready 

LED 

Blinking 

•  Lamp is off but power cord is connected to the projector. 

•  Projector is in standby mode. 

•  Lamp is off and fan is running. 

•  Projector is cooling down. 

Two blinks 

Scaling chip has malfunctioned. 

Three blinks 

System has overheated. 

Four blinks 

I2C bus has failed 

Five blinks 

Lamp has malfunctioned 

Six blinks 

Fan has malfunctioned 

Seven blinks 

Lamp cover is open. 

Power 

LED 

Eight blinks 

DMD board failure. Call for service. 

NOTE 

Every blink will last for 1/2 second and the interval for every blink is lasted 1 second.   

 

Symptom 

Cause and Solution 

Projector responds poorly or 
not at all to the remote 
control. 

•  Make sure that the total distance from the remote to the 

projector is no more than 33 feet (10m). 

•  Point the remote control at the screen or at the front of the 

projector. 

•  Make sure nothing is blocking the infrared sensor on the 

front of the projector. 

•  Darken the room. The light might be effecting the remote 

Control. 

•  Replace the remote control batteries. 

 

Symptom 

Cause and Solution 

No sound 

•  Adjust volume 

•  Verify audio/input connections 

•  Adjust audio source 

Poor sound quality 

•  Make sure your are connected to the earphone jack on   

your laptop or line out jack on your desktop. 

•  Make sure the volume setting on your computers is to the 

halfway point. 

No audio-out port on the 
image source 

You will be not able to connect audio to the projector.