Luxeon D315M Guida Utente



 Digital Projector User’s Guide 

Image is blocked   
PIP window can not 
display video 

Press Menu on the remote and go into the main menu of Utility 

•  To disable PIP Size function   

•  To check PIP Input selection 

Image is “noisy” or 
streaked. 

•  To adjust the frequency 

1.  Press Menu to go into main menu of “Setup”. 
2.  Adjust “ Frequency” and “Tracking” to an optimal setting. 

•  Try connecting with another computer. The problem might be 

due to the video card of the connected computer itself.   

Image is wider at the top 
or bottom of the screen. 

This keystone effect is caused by the projection angle not being 
perpendicular to the screen. To achieve a square image, raise or 
lower the front legs or prop up the back of the projector, or adjust 
keystone function thru remote, or use the EZ Key on the top 
cover of the main set. 

Image is wider at one side 
than the other. 

Make sure the projector is set at a 90 degree angle to the screen.

Projected colors don’t 
match the computer or 
video source colors. 

Press menu to go into main menu of “Color Manager” and adjust 
color temperature & gamma to optimize the colors.   
The Image Manager settings work best if you reset the main 
menu and Adjust to the prior to setting Color Manager. 

Adjust Function can not 
find from Ezkey on main 
set or remote 

Press menu key on the remote to go into several function keys 
selection.  

 

Symptom 

Cause and Solution 

No light is coming from the 
lamp. 

•  Make sure that the power cable is properly connected to a 

fully functional AC electric outlet. 

•  Make sure that the power cord is properly connected to the 

projector. 

•  Make sure that you have removed the lens cap on the 

projector lens at the front of the projector. 

•  Make sure you have pressed the power button and the 

power LED light is a steady green. 

•  Check the projector’s lamp to make sure that it is securely 

connected in the lamp module. 

•  Make sure that the lamp module door is fully closed. 

•  Make sure that the cable connectors do not have any bent 

pins. 

•  Replace the lamp 

Lamp shuts off 

•  A minor power surge may cause the lamp to shut off. Press 

the power button twice to turn off the projector. (The 
power light continues to blink and the fan continues to run 
until the projector cools down.) Wait at least one minute, 
then press the power button again. 

•  Replace the lamp module.