Luxeon D315M Guida Utente



The lamp contains a trace amount of mercury. Some governments require 

special disposal of lamps containing mercury. Dispose of lamps in accordance with the law 
and any applicable local regulations.   
 
The lamp module should be replaced with a certified replacement part.    To order a new 
lamp, contact your local dealer.    After changing the lamp module you should reset the lamp 
hours in accordance with the lamp hour reset instructed hereafter. 
 

When replacing the lamp be sure to turn off power and unplug the power cord. To 
avoid being burned and to prevent an electrical shock, wait 45 minutes before 
opening the lamp module cover and do not touch any hot surface inside. 
Do not loosen or remove any screws other than lamp module or its cover. 
Doing so many cause electric shock. 
 

 
 
To replace the lamp module   
 
 
 
 
 

 
 

 
1.  Turn off the projector and let the unit cool 

down for at least 45 minutes. 

2.  Unplug the power cord from projector. 
3.  Turn the projector upside down. Loosen the 

screw with a phillips screwdriver. Remove the 
lamp cover by lifting it up and out.     

4.  Loosen the three screws on the lamp module 

bracket. 

5.  Gently lift and pull up on the two slotted 

indentation on the located on the lamp 
housing to remove the lamp module.   

6.  Carefully place the new lamp module into the 

projector with the glass portion facing left. 
Insert the lamp module securely and match 
two location ribs to the location holes on the 
inner engine case. Tighten the three screws. 

7.  Reinstall the lamp module cover and tighten 

the screw.   

8.  Turn on the projector. 
9.  Reset the lamp hours.