Affirmative 7375 Guida Utente

YEStablet 7375 User Guide--Operation

 

 

 

 

 
NOTE:   

•  The battery shipped with your tablet should be low in power – please be prepared to use the AC-DC adapter 

with the 7375 in setting up the tablet for the first time and to fully charge the internal battery pack.   

•  Depending on the origin of your tablet, the 7375 is generally delivered in a “Power Off” state.  To start (Cold 

Boot or “Power On”) the 7375 for the first time, push briefly on the Suspend or Power/Reset button (#9 per 
Button Function Table) located at the upper left edge of the tablet with the AC-DC adapter connected to the 
tablet.  You may refer to the sections on Operation Notes and Appendix on FAQ and Troubleshooting for more 
details and scenarios. 

•  Please use (push and quick release) the Suspend button to “sleep” the tablet while not in use.  Pushing briefly 

on the Suspend button will wake up the system within 1-2 seconds.  In general, to activate the 7375, push and 
quickly release the Suspend button to the left of the front bezel.  The display will come on in about 1-2 
seconds.  To move the 7375 into Suspend mode and conserve power, push and quickly release the Suspend 
button.  In the Suspend mode, the tablet continues to consume (a minimum amount of) power. 

•  If you are putting the tablet away for an extended period of time (e.g., travel or absence), you may elect to 

power off the tablet completely to conserve battery life.  This way, you will have power in your battery when 
you arrive at your destination or return from your absence.  However you will need to properly save your work 
content (e.g., to external CompactFlash card in CF slot) and tablet settings (e.g., by Registries Save/Restore 
utility in Control Panel) prior to the procedure.  To power off the tablet, push and hold in the Suspend button 
for over 4 seconds – the display will turn off and all LEDs will be dark.   

•  DO NOT use the Power Off function as part of normal tablet operation – you may lose all firmware settings 

and information you may have established through your pattern of usage.  It is designed to reset the tablet in the 
unlikely event that the tablet enters an unresponsive state or to meet the power conserving objective cited in the 
previous paragraph.  Pushing briefly on the Suspend button will initiate the Power On process if the battery is 
in good condition; otherwise make sure the AC-DC adapter is connected. 

 
 

 
1.  After power up (from Suspend or otherwise), the Windows CE Desktop will be displayed after a launch 

sequence of several seconds OR within 2-4 seconds if recovering from Suspend. 

2.  The wireless LAN adapter may take 10-15 seconds to be (re-)established. 
3.  Choose from any of the displayed icons on the Desktop to activate the corresponding application. 

 
 

 
The Calibration Properties screen will appear before the Windows CE desktop, if this is a new or reset tablet.  
When the 7375 prompts you to calibrate the touch-screen, use the Stylus (stored in the upper right surface of the 
7375) and tap where indicated on the touch-screen in accordance with the displayed instructions. 
(This document refers to “clicking” or “tapping” interchangeably.  The latter is applicable when the touch-screen 
is utilized). 
NOTE: You can recalibrate at anytime using Start” Æ “Settings” Æ “Control Panel” Æ “Stylus” or holding the  
"soft keyboard" button (the left-most one on the bottom side of your tablet) AND the "left-edge" button of the 4-
way navigation switch (located at the front right of your tablet) simultaneously.  
 
 
 

9