Affirmative 7375 Guida Utente

YEStablet 7375 User Guide—Operation Notes

 

 

 

 

 
The 7375 has a PC Card slot along the upper left edge.  This slot normally houses a wireless LAN adapter or Sierra 
wireless cellular adapter.  In certain configurations, the slot is left open for the user to insert a supported network 
adapter.  In the standard configuration, the 7375 is delivered with an embedded PC card 802.11b wireless LAN 
adapter with a custom antenna in a snap-type housing.  In this case, the user has the choice of leaving the antenna in 
the snap-on position (A) or of pulling the antenna tip off the retainer snap and trying to obtain better wireless 
connectivity through varying orientations up to near-vertical (B).  Note: If the antenna is unsnapped, it becomes 
vulnerable to damage.  Any such damage is not covered by the tablet’s limited warranty. 
 

          (A) 

 

 

 

 

      

        (B) 

 

 

 
 
 
 
 
 
 
 
 

 
The 7375 is equipped with an internal Li-Ion battery pack that is capable of supporting approximately 2.5 hours of 
continuous operation.  The period of continuous operation can be extended to approximately 6 hours with the aid of 
an optional external battery pack that clips onto the back of the tablet.  The period between battery recharge can be 
significantly lengthened by putting the tablet into Suspend mode through the Suspend button (see 

) whenever the tablet is not in use.  The 7375 may also be configured to automatically enter into power-saving 

modes after user-definable periods of tablet idle – see Start > Settings > Control Panel > Power. 
 
NOTE:   Both the internal and external 7375 battery packs may be recharged with the accompanying AC-DC 
adapter connected directly to the DC-in jack on the tablet or connected to the tablet Cradle.  The external pack can 
also be charged in the optional auxiliary battery charger cradle (see 

). 

 

 
The Power (Reset) and Suspend (Resume) button resides, slightly recessed, along the upper left edge of the 7375. 
 
•  Suspend/Resume 

A brief push/release of the Suspend button toggles between Suspend and Resume – with adequate intervening 
time.  The system cannot enter into Suspend mode again within 15 seconds after Resuming.   

 
•  COLD Boot/Power On-Off/Reset 

You may use the Suspend button to Cold Boot or Restart the 7375 in the unlikely event of tablet lock-up.  To 
execute, push on the button for over 4 seconds to “Power Off” the tablet.  The tablet will be turned off.  This 
Reset/Power Off will clear your firmware settings and data if they are not properly saved to flash memory (See 

 for reference).  Push again on Suspend for a brief moment to restart/reboot the tablet. 

 

17