IQinVision iqm30ne-b5 Istruzione Sull'Installazione
6
7. Removal of Dome Cover
1. Using the supplied Torx T-20 security wrench,
loosen the three tamper-proof screws holding
the dome cover to the enclosure assembly
(Figure 7.1). Note that these screws are
captive, and held to the dome cover. These
screws should not be removed from the dome
cover trim ring.
the dome cover to the enclosure assembly
(Figure 7.1). Note that these screws are
captive, and held to the dome cover. These
screws should not be removed from the dome
cover trim ring.
2. Lift the dome trim ring with shroud away from the camera assembly.
8. Mounting the Enclosure, Camera,
and Lens Assembly
Mounting to masonry or other durable surface wall, ceiling or overhang with cables
routing through the wall or ceiling.
routing through the wall or ceiling.
1. Position the supplied mounting template on the surface in the location where the
camera will be installed. Trace and drill the mounting holes and the cable pass
through hole as indicated.
through hole as indicated.
2. Route the network cable through the wall.
3. Gently push the Ethernet cable through the gasket
installed in the enclosure. Pull enough cable through the
gasket to attach an RJ-45 network connector, and to allow the
network connector to plug into the Ethernet socket
(Figure 8.1).
gasket to attach an RJ-45 network connector, and to allow the
network connector to plug into the Ethernet socket
(Figure 8.1).
It may be necessary to pierce a hole in the gasket
with an Awl tool (not supplied).
NOTE:
• Do not cut the gasket with a knife.
• Do not force the Ethernet cable with connector
• Do not cut the gasket with a knife.
• Do not force the Ethernet cable with connector
through the gasket.
• Only pass one cable through the supplied gasket.
Figure 7.1
Figure 8.1
Figure 8.2