IQinVision iqm30ne-b5 インストール手順

1.  Using the supplied Torx T-20 security wrench,  

loosen the three tamper-proof screws holding  
the dome cover to the enclosure assembly  
(Figure 7.1). Note that these screws are  
captive, and held to the dome cover.  These  
screws should not be removed from the dome  
cover trim ring.

2.  Lift the dome trim ring with shroud away from the camera assembly.

Mounting to masonry or other durable surface wall, ceiling or overhang with cables 
routing through the wall or ceiling.

1.  Position the supplied mounting template on the surface in the location where the 

camera will be installed.  Trace and drill the mounting holes and the cable pass 
through hole as indicated.

2. Route the network cable through the wall.

3.  Gently push the Ethernet cable through the gasket  

installed in the enclosure.  Pull enough cable through the 
gasket to attach an RJ-45 network connector, and to allow the 
network connector to plug into the Ethernet socket  
(Figure 8.1). 

 
It may be necessary to pierce a hole in the gasket  
with an Awl tool (not supplied).