NorthStar 961 Istruzione Sull'Installazione
SECTION TWO - Installation
961/962 INSTALLATION MANUAL Revision A
Page 21
Figure 10: Combo GPS/DGPS antenna (AN205-P)
Wiring the AN205-P antenna
When using the AN205-P combo antenna, a cable “splitter” is required to
separate the signal path of the single cable from the antenna into two
cables for connection to the 961/962. For the proper installation of the
splitter, refer to “Figure 11: Correct AN205-P (combo antenna) splitter
wiring” below. The splitter should be located for convenience near the
961/962, but can be situated virtually anywhere along the length of the
maximum 100 feet of RG-59 GPS cable without appreciable signal loss.
Note that the splitter isn’t weatherproof and should be placed in an area
that’s protected from direct water splash or spray.
separate the signal path of the single cable from the antenna into two
cables for connection to the 961/962. For the proper installation of the
splitter, refer to “Figure 11: Correct AN205-P (combo antenna) splitter
wiring” below. The splitter should be located for convenience near the
961/962, but can be situated virtually anywhere along the length of the
maximum 100 feet of RG-59 GPS cable without appreciable signal loss.
Note that the splitter isn’t weatherproof and should be placed in an area
that’s protected from direct water splash or spray.
CAUTION!
The combo antenna must be used with a minimum of 20 feet
of cable and no more than 100 feet. Coil up any unused
length; do not cut it to less than 20 feet!
of cable and no more than 100 feet. Coil up any unused
length; do not cut it to less than 20 feet!
7.00
2.5
3.5
TNC
Locking nut