Garmin 530w Guida Utente
5 - PROCEDURES
86
Procedure Turn Approach
RW04
31 nm
DO NOT
USE FOR
NAVIGATION
2. Several miles prior to reaching the IAF (LYH),
you may wish to review the approach sequence.
Press the FPL key to display the Active Flight
Plan Page. Press the small right knob and turn
the large right knob to review each segment
of the approach. When finished, press FPL
again to return to the previous page.
Press the FPL key to display the Active Flight
Plan Page. Press the small right knob and turn
the large right knob to review each segment
of the approach. When finished, press FPL
again to return to the previous page.
3. As you approach the IAF (LYH), a waypoint
alert (“Next DTK 205° in x sec”) appears in
the lower right corner of the screen. As the
distance (DIS) to the IAF approaches zero, the
alert is replaced by a turn advisory (“Left to
205° in x sec”). Dial the outbound course of
205° into the CDI (or HSI) using the OBS knob
and initiate a standard rate turn to this course
heading.
the lower right corner of the screen. As the
distance (DIS) to the IAF approaches zero, the
alert is replaced by a turn advisory (“Left to
205° in x sec”). Dial the outbound course of
205° into the CDI (or HSI) using the OBS knob
and initiate a standard rate turn to this course
heading.
As you approach the IAF, the “Left to 209° in x sec” waypoint
alert appears in the lower right corner. Prepare to turn to this
heading.
4. Fly the outbound course, keeping the CDI
needle centered.
5. Once you have flown approximately one minute
past the IAF (LYH), the alert message “Left to
160° in x sec” appears in the lower right corner
of the screen. You may initiate the procedure turn
at any time after receiving this alert message.
160° in x sec” appears in the lower right corner
of the screen. You may initiate the procedure turn
at any time after receiving this alert message.
At approximately one minute past the IAF, an alert message
(“Left to 160° in x sec”) reminds you to begin the procedure
turn.
6. Turn left to a heading of 160° to initiate the
procedure turn. Course guidance is provided
relative to the outbound leg from the FAF. (The
procedure turn is displayed on the Map Page
and indicated as the active leg on the Default
NAV and Active Flight Plan pages.) The CDI
needle starts moving to the right.
relative to the outbound leg from the FAF. (The
procedure turn is displayed on the Map Page
and indicated as the active leg on the Default
NAV and Active Flight Plan pages.) The CDI
needle starts moving to the right.