Anchor acc-6000u1 Descrizione Prodotto

Rated Power Output 

50 watts continuous @ 4 ohm

Max SPL @ Rated Power  103 dB @ 1 meter
Frequency Response 

65 Hz – 20 kHz ± 3 dB

Speaker Type 

4.5” woofer w/ shielded magnet,

 

10mm dome tweeter

AC Power Reqs. 

110 – 125Vac, 50/60 Hz, 90W Max

     Export Model 

208 – 240Vac, 50/60 Hz, 90W Max

Dimensions 

(HWD) 

5.25 x 8.4 x 9” / 13 x 21 x 23 cm

Weight 

9.5 pounds / 4.3 Kg

Tone Controls
Bass 

+8 – 12 dB @ 100 Hz

Treble 

+10 – 12 dB @ 10 kHz

(Specifications subject to change without notice)

Inputs
Balanced 

female XLR, switchable phantom 

power, 15 volts DC @ 6.8 k ohm
Mic-Level Setting 

Lo-Z

Line-Level Setting 

Bridging (10 k ohm)

Line 

Hi-Z, unbalanced, 1/4”-phone & RCA

Outputs
Line (post fader) 

Lo-Z, buffered, RCA

Speaker 

8 ohm, unswitched, 1/4”-phone

Sensitivity For Rated Output
Line 

balanced -18 dBv (125 mVrms)

Microphone 

balanced -56 dBv (1.5 mVrms)

Line 

-18 dBv (125 mVrms)

GETTING STARTED ................................................................................................................................................. 2
FEEDBACK ............................................................................................................................................................... 3
BASIC SYSTEM OPERATION .................................................................................................................................... 4
BALANCED INPUT JACK .......................................................................................................................................... 4
AN-1000X  ACCESSORIES ........................................................................................................................................ 6
IMPORTANT SAFEGUARDS ..................................................................................................................................... 7
HAVING TROUBLE W/ YOUR SOUND SYSTEM? ...................................................................................................... 8
AN-1000X TECHNICAL SPECIFICATIONS ................................................................................................................ 8

No Sound 

(Power LED Not Lit) 

• turn POWER switch on

 

• plug in power cord

 

• check for blown fuse

No Sound 

(Power LED Lights) 

• check for output from source

 

• make sure all cables are completely plugged in

 

• increase volume control

Distorted Sound 

• check input cable connection

 

• lower input signal level

Excessive Hum / Noise 

• use shielded input cable

Mic Volume Too Low 

• set balanced input to mic-level

Blows Fuse w/ Auxiliary Speaker 

• shorted speaker cable

Portable Sound Systems  •  Torrance, California

100-0026-000/G - 9/06