Anchor acc-6000u1 Descrizione Prodotto
3
FEEDBACK
Feedback is a howling noise or shrill sound that is self-generated by the sound system. It is caused by a microphone
picking up the sound coming from the speaker and then being re-amplified. Once a feedback loop is started it will
continue until the system is adjusted.
picking up the sound coming from the speaker and then being re-amplified. Once a feedback loop is started it will
continue until the system is adjusted.
FEEDBACK CAUSES
• Microphone too close, pointing towards or in front of the speaker
• Volume setting too loud for room
• Sound reflections from hard surfaces, walls, etc.
• Volume setting too loud for room
• Sound reflections from hard surfaces, walls, etc.
AVOIDING & ELIMINATING FEEDBACK
• Point the microphone in a different direction
• Keep the microphone away from the speaker; position speaker in FRONT of microphone
• Reduce the sound system volume levels
• Keep the microphone away from the speaker; position speaker in FRONT of microphone
• Reduce the sound system volume levels
CAUTION: Feedback can damage your equipment & may be hazardous to hearing.
PROBLEMS? Consult the troubleshooting section on the back page of this manual
or call Anchor Audio Customer Service - 888-444-6077.
6
AN-1000X ACCESSORIES
MIC-90 - Handheld Microphone
Anchor’s dynamic, balanced, low impedance micro-
phone with a unidirectional pick-up pattern. It has an
on/off switch and comes w/ a 20’ cable & mic clip.
AN-1001X - Companion Speaker
Unpowered speaker for use with the AN-1000X. It
has a 1/4”-phone input jack and parallel input/output
wire terminals. Designed to accept Omnimount
Anchor’s dynamic, balanced, low impedance micro-
phone with a unidirectional pick-up pattern. It has an
on/off switch and comes w/ a 20’ cable & mic clip.
AN-1001X - Companion Speaker
Unpowered speaker for use with the AN-1000X. It
has a 1/4”-phone input jack and parallel input/output
wire terminals. Designed to accept Omnimount
®
25-series mounts. Speaker cable not included.
SS-250 - Speaker Stand
Collapsible speaker stand. Rated load capacity 25
pounds.
SS-250 - Speaker Stand
Collapsible speaker stand. Rated load capacity 25
pounds.
(Requires SB-1 bracket sold separately)
SB-1 - Stand Mounting Bracket
U-shaped swivel bracket. Mounts to a wall, ceiling or
on a speaker stand.
U-shaped swivel bracket. Mounts to a wall, ceiling or
on a speaker stand.
(Adapter included)
RM-1 - Single Rackmount Kit
Mounts one AN-1000X in a standard equipment rack.
Mounts one AN-1000X in a standard equipment rack.
RM-12 - Dual Rackmount Kit
Mounts two AN-1000X’s in a standard equipment rack.
SC-50 - Speaker Cable
Heavy duty speaker cable - 50’.
MSB-201 - Combo Mic/Speaker Stand
Floor stand w/ 33” adjustable boom. Speaker stand
when combined w/ SB-1 mounting bracket.
HS-1 - Carry Handle
Convenient attachable handle for AN-1000X.
HC-1550 - Hard Case
Traveling hard case, holds up to two AN-1000X’s, two
mics & accessories.
Mounts two AN-1000X’s in a standard equipment rack.
SC-50 - Speaker Cable
Heavy duty speaker cable - 50’.
MSB-201 - Combo Mic/Speaker Stand
Floor stand w/ 33” adjustable boom. Speaker stand
when combined w/ SB-1 mounting bracket.
HS-1 - Carry Handle
Convenient attachable handle for AN-1000X.
HC-1550 - Hard Case
Traveling hard case, holds up to two AN-1000X’s, two
mics & accessories.