Ricoh 2035e Manuale Utente
Polling Transmission
11
1
r You can set whether a Polling
Transmission file is deleted after
transmitting in User Parameters.
To save the file to transmit repeat-
edly, set to “Standby (Save)”. See
p.159 “User Parameters” (switch
11, bit 7).
transmitting in User Parameters.
To save the file to transmit repeat-
edly, set to “Standby (Save)”. See
p.159 “User Parameters” (switch
11, bit 7).
r Polling Transmission Clear Report
allows you to verify Polling Trans-
mission has taken place. See p.12
“Polling Transmission Clear Re-
port”. If E-mail TX Results is pro-
grammed in a Quick Operation
key, you can select whether a re-
port e-mail is sent after transmis-
sion. The destination of this report
can be selected from the e-mail ad-
dresses in the destination list.
mission has taken place. See p.12
“Polling Transmission Clear Re-
port”. If E-mail TX Results is pro-
grammed in a Quick Operation
key, you can select whether a re-
port e-mail is sent after transmis-
sion. The destination of this report
can be selected from the e-mail ad-
dresses in the destination list.
r You can program one of the Quick
Operation keys with operations for
this function. Using the key allows
you to omit steps
this function. Using the key allows
you to omit steps
B and C.
r The communication fee is charged
to the receiver.
r This function is not available with
Internet Fax transmission.
A
Place the original, and then select
the scan settings you require.
the scan settings you require.
Reference
B
Press
[
Transmission Mode
]
.
C
Press
[
Polling TX
]
.
D
Depending on the Polling Trans-
mission mode, use one of the fol-
lowing procedures:
mission mode, use one of the fol-
lowing procedures:
Free Polling Transmission
A Check that
[
Free Polling TX
]
is se-
lected.
Default ID Transmission
A Select
[
Default ID TX
]
.
ID Override Transmission
A Select
[
ID Override Transmission
]
.
B Specify a 4-digit ID using the
number keys and
[
A
]
,
[
B
]
,
[
C
]
,
[D
]
,
[
E
]
, and
[
F
]
.
Note
r A Polling ID may be any four
numbers (0 to 9) and charac-
ters (A to F), except 0000 and
FFFF.
ters (A to F), except 0000 and
FFFF.
r If you make a mistake, press
[
Clear
]
or the {Clear/Stop} key,
and then try again.