Logic Controls kb3000 Manuale Utente
3
HARDWARE CONNECTIONS
The KB3000 can be connected to an IBM101 PC, XT, AT or clone
computer, PS/2 computer, or computer terminal. The following diagram
shows how the KB3000 connects to the computer and standard key-
board or other keyboard peripheral (magnetic stripe reader, scanner,
etc.). When the KB3000 is used in a stand alone configuration then no
connections are made to J5.
computer, PS/2 computer, or computer terminal. The following diagram
shows how the KB3000 connects to the computer and standard key-
board or other keyboard peripheral (magnetic stripe reader, scanner,
etc.). When the KB3000 is used in a stand alone configuration then no
connections are made to J5.
NOTE:
Before making any connections it is always advisable to
turn off the computer.
turn off the computer.
A. Connecting the KB3000 to an IBM101 PC, XT, AT, or Clone
computer’s keyboard port:
1.
Use the supplied interface cable. Plug the 6-pin connector into J2
of the KB3000. Plug the 5-pin connector into the computer’s
keyboard port.
of the KB3000. Plug the 5-pin connector into the computer’s
keyboard port.
2.
Connect the computer’s keyboard into J5 of the KB3000.
NOTE:
J1 and J6 are not used in this configuration.
To computer
keyboard port
keyboard port
To computer keyboard or
other keyboard wedge devices
other keyboard wedge devices