Logic Controls kb3000 Manuale Utente

4

1.

Use the supplied interface cable.  Plug in the 6-pin DIN
connector of the interfacecable into J2 of the KB3000.

2.

Connect the 5 pin DIN connector of the interface cable into the 5
pin DIN of the  AT-to-PS/2 adapter.

3.

Plug the PS/2 connector of the adapter into the computer’s key
board port.

4.

Connect the PS/2 keyboard into J1 of the KB3000.

NOTE 1:     J5 and J6 are not used in this configuration.

NOTE 2:     The AT-to-PS/2 adapter is not supplied but can be ordered

      from the manufacturer.

1.

Connect J6 of the KB3001-R9 to a RS232 port of the computer
terminal using the RS232C interface cable supplied.

NOTE 1:

J1, J2, and J5 are not used in this configuration.

NOTE 2:

 A different utility program comes with all KB3001-R9
keypads.  An RS232C interface cable is included with all
KB3001 keypads.

NOTE 3:

Programming the KB3001-R9 must be done on a PC computer.
When programming is completed, remove the cable going to
J6 and install the RS232C interface cable.

NOTE 4:

Before writing the file to the keypad open the F3 menu and
set the RS232C option to YES.  Make any changes necessary
to the communications protocol setup.