Intermec 5020 Guida Utente

You can now configure and start the dcBrowser client. For help, see 

.

Before you can run the dcBrowser client, you need to configure your 
Intermec computer for networking and then configure dcBrowser to use 
either TCP/IP or UDP Plus.

You need to perform these tasks:

• Configure the Intermec computer for networking.

• Configure the Intermec computer for TCP/IP or UDP Plus 

communications.

Select Start > Settings > Control Panel. The Control Panel appears.

Double-tap Network and Dial-up Connections.

Double-tap the network adapter you are using for your network 
configuration. For example, use the 802.11b PRISM Wireless LAN 
adapter if your network is configured with an 802.11b wireless access 
point.

If you are using a dynamic host configuration protocol (DHCP) server, 
select Obtain an IP address via DHCP.

If you are not using a DHCP server, select Specify an IP address and 
enter the IP address, subnet mask, and default gateway for your mobile 
computer. Your network administrator should provide you with this 
information.

(Optional) On the Name Servers tab, enter the IP addresses for the 
primary and secondary DNS servers and for the primary and secondary 
WINS servers.

Tap OK.

Tap the X button in the upper right corner of the screen.

If your network is configured for wireless 802.11, double-tap the 
Wireless Network icon.

TCP/IP

You need to determine the dcBrowser gateway port number (which 
defaults to 4055) and the IP address of the computer where the 
dcBrowser gateway is hosted.

UDP Plus

You need to determine the UDP Plus port number (which defaults to 
5555) and the IP address of the controller, which is the Intermec 
Application Server or PC that the dcBrowser gateway is running on.