Fedders aep09d2a Guida Al Funzionamento

Condensed water may accumulate in the unit. If the

internal tank becomes full, the Warning Light will shine
and the unit will not operate until the unit has been
drained.

First, uplug electrical cord from wall outlet. Then, drain
excess water from the tank by placing a pan under the
drain valve, removing the drain plug, and letting the
water drain into the pan. 

When the water stops draining out, replace the drain
plug, and remove the pan of water. Operate the air
conditioner in fan mode to dry the interior of the unit.

Always drain the unit before putting it into storage.

• The unit has an air filter that must be cleaned with

water every two weeks and put back in the unit after it
is completely dry.

• The air discharge grille can be cleaned with a rag or

sponge, warm water and mild detergent.

• Never use hot water, bleach, gasoline, acids, cleaning

fluid or a brush to clean the unit. This will damage the
cabinet and the air discharge area.

• Do not wash the unit with a hose.

1. Turn Power OFF.
2. Remove the air filter by grasping the bottom  and

pulling it up and out of the unit.

3. Wash in hot soapy water, rinse and shake dry.
4. Replace the filter with the front of the filter toward you. 
5. To dry the filter thoroughly, run your unit in fan mode

for a few minutes. Remember, only a clean filter works
properly and delivers top efficiency at every setting.

IEC R03

1.5V

IEC R03

1.5V

The functions work the same as your air conditioner’s
touch controls.

Batteries:  Remove the cover on the back of the remote
controller and insert the batteries with the (+) and (-)
poles pointing in the proper direction.

Drain Valve

10

11