Fedders b6y12f2a Guida Al Funzionamento

Pagina di 28
SERVICE
TROUBLESHOOTING
8
Occurrence
Possible Cause
Solutions
Air conditioner will not operate
• Wall plug disconnected.
✔ Push plug firmly into wall outlet.
• House fuse blown or circuit breaker tripped.
✔ Replace fuse with time delay type 
or reset circuit breaker.
• Power switch in OFF position.
✔ Turn power switch to ON position.
• Unit accidentally turned off by moving the 
✔ Wait approximately 3 minutes.
thermostat to a higher temperature and then
Listen for the compressor to start. 
immediately turned back to a colder position.
• Unit turned off and then on too quickly.
✔ If air conditioner is turned off, 
wait 3 minutes before restarting.
• Thermostat set too low for cooling.
✔ Adjust thermostat to higher setting for cooling.
Air from unit does not 
• Selector in FAN position.
✔ Set selector to COOL position.
feel cold enough
• Thermostat set too warm.
✔ Set thermostat to colder temperature.
• Room temperature below 70°F.
✔ Cooling may not occur until room 
temperature rises above 70°F.
Air conditioner cooling,
• Outdoor temperature below 70°F.
✔ To defrost the coil, set selector to FAN position.
but room is too warm —
Then, set thermostat to warmer position.
ice forming on cooling coil
• Dirty air filter — air restricted.
✔ Clean filter. See “Cleaning the Air Filter” section.
behind decorative front
To defrost, set selector to FAN.
• Thermostat set too cold for nighttime cooling.
✔ To defrost the coil, set selector to FAN position.
Then, set thermostat to a normal position.
Air conditioner cooling,
• Dirty air filter — air restricted.
✔ Clean air filter. 
but room too warm — 
Refer to “Cleaning Air Filter” section.
NO ice forming on cooling coil
• Thermostat set too warm.
✔ Set thermostat to colder setting.
behind decorative front
• Fan selector set on LOW.
✔ Set fan speed selector to HIGH 
for maximum cooling.
Noise when unit is cooling
• Air movement sound.
✔ The sound of rushing air is normal. If too loud,
turn selector to lower fan setting.
• Sound of fan hitting water-moisture 
✔ This is normal when humidity is high. 
removal system.
Close doors, windows and registers.
• Window vibration — poor installation.
✔ Refer to installation instructions — 
check with installer.
Water dripping inside
• Improper installation.
✔ Tilt air conditioner slightly to the outside to  
when unit is cooling
allow water drainage. Refer to installation 
instructions — check with installer.
Water dripping outside
• Unit removing large quantity of moisture
✔ This is normal during excessively humid days. 
when unit is cooling
from humid room.
Service
To save time and expense, check the following before calling an authorized service center. 
For Models Installed in North America - If Service or Parts are Required 
First, make the recommended checks. If it appears that
service or parts are still required, see your room air conditioner warranty “How to Obtain Warranty Service or Parts”.
For Models Installed Outside North America  
For room air conditioners purchased for use outside North America, the
manufacturer does not extend any warranty either expressed or implied. Consult your local dealer for any warranty terms
extended by the importer in your country.
Visit www.fedders.com for obtaining service parts beyond your warranty period.
Troubleshooting Guide