Fedders hfc1009n2f Guida Al Funzionamento

6

INDOOR UNIT INSTALLATION

Remove the base cover to access tubing and wire connections.

•  Use a flat head screwdriver to un-latch the base cover tabs from

the indoor unit. The tab locations are indicated by ’triangle’
markings on the base plate.

•  Do not twist the screwdriver to dislodge the base cover from the

indoor unit; doing so will damage the plastic part

Base cover tabs

• Wiring connections to the indoor unit must be completed before

attaching it to the wall bracket

• Hook the unit onto the hangers on top of the wall bracket

•  Ensure that the unit is level

•  Ensure that the drain hose, tubing, and connecting wires are

aligned and in the proper position

Hook the unit to the hangers on top
of the wall bracket

Connect the wires to the indoor unit by opening the decorative
front grille and following these steps:

• Remove the screw that secures the control box cover

•  Connect the wiring as shown on the wiring diagrams on page 2

(a wiring diagram can also be found on the unit)

• Route the wiring from the back and up through the opening in

the front as shown in figure 7

•  Ensure all terminals are securely tightened

Route wire through here
and up to the front

Wire from the back and
through this opening

Control box cover

Front view

Rear view