Fedders hfc1009n2f Guida Al Funzionamento

5

•  Secure the wall bracket directly to the wall and into wall  studs

using screws provided as shown in figure 3

•  If wall studs are not available, it is recommended to  use a toggle 

bolt or similar drywall anchor

•  If you are mounting the bracket on a concrete wall, use anchor

bolts to secure the top of the bracket to the wall

•

Do not overtighten the bottom two screws causing the bracket
to bend. There should be a .20 inch gap between the bracket
and wall

Make sure the wall bracket is level. 

If the wall unit is not mounted level, condensate water will leak
from the unit and can damage walls and/or carpet underneath.

INDOOR UNIT INSTALLATION

Minimum 5.5”

to ceiling

Minimum 5.5”

to wall

Minimum  7”

to wall

Fasten wall bracket to wall studs with screws

Drill a 2.5” diameter tubing hole at either the right or the
left. The hole should be slightly slanted to the outdoor
side. Your application may vary. See figure 4 for different
tubing outlet location options.

Drill a 2.5” diameter tubing
access hole to route the
tubing to the outdoor unit.
The hole should be slightly
slanted to the outdoor side. 

A typical installation will use a
Right or Left back outlet as
illustrated in figure 3.  

See figure 4 for  different
configurations to suit your
application. 

Left Bottom Outlet

Left Back Outlet

Left Outlet

Right Bottom Outlet

Right Back Outlet

Right Outlet

There should be a .20 inch gap
between the bracket and wall