Fedders hfc1009n2f Guida Al Funzionamento

8

OUTDOOR UNIT INSTALLATION

•  Locate the outdoor unit where the air flow around it will not

be obstructed

•  Check that the base is level and does not exceed the maximum

slope of five degrees

•  Secure the unit to a base with anchor bolts to reduce

vibrations and noise

•  Allow adequate space to access the unit for service and

maintenance

•  Maintain a minimum distance  around the unit  as shown in

figure 12

•  Do not install the unit near a heat source, steam source or

flammable gas

•  Heatpump units should be mounted above the snow line, 

if possible

•  Attach the base leg dampers by sliding the damper slots onto

the base of the outdoor unit as shown in figure 13

•  Attach the drain gasket and drain adapter to the base pan of

the unit before you secure the unit (applicable to heat pump
models only) as shown in figure 13

•  Fasten the unit onto the base

At least 24”

At least 16”

At least 4”

At least 24”

Base leg dampers

Drain adapter  (heat pump models only)

At least 24”