Adaptec rs Guida Utente
5-1
Removing and Installing Components
Chapter 5: Removing and Installing Compo-
nents
This chapter deals with field replacing components in the RAIDStation7 Fibre
Channel Storage Array. Procedures for removing and installing components such
as disk drives, power supplies, ACMs, the VEM, and the port bypass circuit mod-
ule are covered. The procedure for replacing a rackmount Storage Array in an
equipment rack is also described.
Channel Storage Array. Procedures for removing and installing components such
as disk drives, power supplies, ACMs, the VEM, and the port bypass circuit mod-
ule are covered. The procedure for replacing a rackmount Storage Array in an
equipment rack is also described.
Device Carrier Removal and Installation
The horizontal, rackmount position of the power supplies and disk drives within
the RAIDstation7 Fibre Channel Storage Array are shown in Figure 5-1. In the
vertical, upright position, bay 0 is on top, bay 8 on the bottom.
the RAIDstation7 Fibre Channel Storage Array are shown in Figure 5-1. In the
vertical, upright position, bay 0 is on top, bay 8 on the bottom.
Figure 5-1. Location of Devices in RAIDStation7 Fibre Channel Storage
Array
WARNING: Before attempting to install or remove any of the components,
ensure that anti-static precautions have been taken. The minimum require-
ment is a properly grounded anti-static wrist strap and grounding wire.
ensure that anti-static precautions have been taken. The minimum require-
ment is a properly grounded anti-static wrist strap and grounding wire.
Power
S
upply
Power
S
upp
ly
Disk
Drive 7
Disk Drive
6
Disk Drive 5
Dis
k
D
rive
4
rive
4
Disk
Drive 3
Disk Drive 2
Disk
Drive 1
Bay 0
Bay 8