Calflame cr2000 Manuale Utente

2007 Barbecue Grill and Cart Owner’s Manual 

Page 13

LTR20071038, Rev. B

Prepare the installation of handle: 2 hex screws, 2 
washers 

Use finger to thread the hex screws and washers 
into the threads on both ends of the handle.

Use ratchet to tighten the hex screws on both ends. 
The handle has been installed onto the shelf.

Take the three screws off on both sides of the cart 
to install the mounting bracket. 

Install the mounting brackets on both sides. Make 
sure the mounting brackets are in the correct 
orientation. Two mounting brackets have been 
installed onto the cart.

1.

2.

3.

4.

5.

Slides the shelf into the brackets from bottom.

Make sure to slide into the brackets on both side 
evenly.

Slide the shelf fully onto the mounting brackets.

Lift and rotate the shelf so it slide back into the 
brackets.

Keep the shelf in the normal open position.

Prepare to install stop brackets under the mounting 
brackets on  both sides. 

Remove one screw and loose the other screw so 
the stop bracket can be placed as shown. Tighten 
both screw to hold the stop bracket.

6.

7.

8.

9.

10.

11.

12.

Attach the two brackets to the sides of the grill, one on each 
side, using two screws as shown below.

Slide the rotis motor on one of the brackets as shown below. 
The rotis motor will work on either side of the grill.

Remove the metal cap protecting the outlet that 
provides power for the rotis motor. Plug in the 
motor cord and screw on the retainer nut to keep 
the plug in place.