Wasp wpa206 Guida Di Riferimento
38
Wasp WPA206
Installing the Wireless Local Area Network (WLAN) Card
RF Card Cushion
Remove the protective backing from the sticky side of the RF Card Cushion and
install the cushion along the inside upper edge of the PCMCIA Cover as shown.
The RF Card Cushion prevents damage to the RF card antenna in case the
WPA206 is accidentally dropped.
install the cushion along the inside upper edge of the PCMCIA Cover as shown.
The RF Card Cushion prevents damage to the RF card antenna in case the
WPA206 is accidentally dropped.
Re-attach cover to the WPA206
Setting Up the Wireless Card
The WPA206 is pre-loaded with connection software
from Cisco and Lucent WaveLAN (Agere Orinoco). The
WPA206 will automatically detect these RF cards and
then display the following screen during the first-time
installation. Please note that there are two ways to set
the IP address:
from Cisco and Lucent WaveLAN (Agere Orinoco). The
WPA206 will automatically detect these RF cards and
then display the following screen during the first-time
installation. Please note that there are two ways to set
the IP address:
Insert the RF card into the PCMCIA slot.
Attach pulling-tag to antenna.
Remove the stylus, using the screw driver
in the stylus to remove the screw, and
then open the PCMCIA compartment.
in the stylus to remove the screw, and
then open the PCMCIA compartment.
Power off the WPA206.
Attach the snap-on antenna to the RF card
if required (only the Cisco card comes
with a pre-installed antenna).
if required (only the Cisco card comes
with a pre-installed antenna).
PCMCIA card
front side
PCMCIA card
front side