3com S7906E Guida Di Riferimento
1-5
z
If you have specified an RRPP ring ID in the command, RRPP message statistics of the specified
RRPP ring in the specified RRPP domain on the current device appears. Otherwise, RRPP
message statistics of all RRPP rings in the specified RRPP domain appears.
z
If some port belongs to more than one ring, its packets are taken statistics based on the rings. You
will view the statistics of the port under the current ring.
z
When a ring transits from inactive status into active status, its packets will be counted again..
Related commands: reset rrpp statistics.
Examples
# Display RRPP message statistics of ring 1 in RRPP domain 1.
<Sysname> display rrpp statistics domain 1 ring 1
Ring ID : 1
Ring Level : 1
Node Mode : Master
Active Status : Yes
Primary port : GigabitEthernet3/0/1
Packet Link Common Complete Edge Major Packet
Direct Hello Down Flush FDB Flush FDB Hello Fault Total
------------------------------------------------------------------------
Send 16424 0 0 1 0 0 16425
Rcv 0 0 0 0 0 0 0
Secondary port: GigabitEthernet3/0/2
Packet Link Common Complete Edge Major Packet
Direct Hello Down Flush FDB Flush FDB Hello Fault Total
------------------------------------------------------------------------
Send 0 0 0 0 0 0 0
Rcv 16378 0 0 1 0 0 16379
# Display RRPP message statistics of RRPP domain 2.
<Sysname> display rrpp statistics domain 2
Ring ID : 1
Ring Level : 0
Node Mode : Master
Active Status : Yes
Primary port : GigabitEthernet3/0/3
Packet Link Common Complete Edge Major Packet
Direct Hello Down Flush FDB Flush FDB Hello Fault Total
------------------------------------------------------------------------
Send 16924 0 0 1 0 0 16925
Rcv 0 0 0 0 0 0 0
Secondary port: GigabitEthernet3/0/4
Packet Link Common Complete Edge Major Packet
Direct Hello Down Flush FDB Flush FDB Hello Fault Total
------------------------------------------------------------------------
Send 0 0 0 0 0 0 0
Rcv 16878 0 0 1 0 0 16879
Ring ID : 2