3com S7906E Guide De Référence

1-5

If you have specified an RRPP ring ID in the command, RRPP message statistics of the specified

RRPP ring in the specified RRPP domain on the current device appears. Otherwise, RRPP

message statistics of all RRPP rings in the specified RRPP domain appears.

If some port belongs to more than one ring, its packets are taken statistics based on the rings. You

will view the statistics of the port under the current ring.

When a ring transits from inactive status into active status, its packets will be counted again..

Related commands: reset rrpp statistics.

Examples

# Display RRPP message statistics of ring 1 in RRPP domain 1.

<Sysname> display rrpp statistics domain 1 ring 1

Ring ID : 1

Ring Level : 1

Node Mode : Master

Active Status : Yes

Primary port : GigabitEthernet3/0/1

Packet Link Common Complete Edge Major Packet

Direct Hello Down Flush FDB Flush FDB Hello Fault Total

------------------------------------------------------------------------

Send 16424 0 0 1 0 0 16425

Rcv 0 0 0 0 0 0 0

Secondary port: GigabitEthernet3/0/2

Packet Link Common Complete Edge Major Packet

Direct Hello Down Flush FDB Flush FDB Hello Fault Total

------------------------------------------------------------------------

Send 0 0 0 0 0 0 0

Rcv 16378 0 0 1 0 0 16379

# Display RRPP message statistics of RRPP domain 2.

<Sysname> display rrpp statistics domain 2

Ring ID : 1

Ring Level : 0

Node Mode : Master

Active Status : Yes

Primary port : GigabitEthernet3/0/3

Packet Link Common Complete Edge Major Packet

Direct Hello Down Flush FDB Flush FDB Hello Fault Total

------------------------------------------------------------------------

Send 16924 0 0 1 0 0 16925

Rcv 0 0 0 0 0 0 0

Secondary port: GigabitEthernet3/0/4

Packet Link Common Complete Edge Major Packet

Direct Hello Down Flush FDB Flush FDB Hello Fault Total

------------------------------------------------------------------------

Send 0 0 0 0 0 0 0

Rcv 16878 0 0 1 0 0 16879

Ring ID : 2