Xerox 7228 Guida Utente

296 

Use the following check list to troubleshoot your network communication problem. 

Before you start 

It is assumed that you purchased the Scanning option to enable Scanning to the Hard Drive with your 
Device.  If you did not, contact your Xerox Representative to purchase this option. 

Check Physical Media and Network Interface Cards 

1.  Verify that the Device is powered ON. 

2.  Verify that the Device and Workstation are using the correct cabling to communicate over the 

network.  Use category 3 UTP patch (NOT crossover) cable for 10 Base T communications, category 
5 UTP patch (NOT crossover) cable for 10 Base T / 100 Base TX communications, and Token Ring 
cabling for Token Ring networks. 

3.  Verify that the cable at both the Device and Workstation is fully plugged into the Network Interface 

Card (NIC).  Check the link light, which is typically a green LED, to make sure that it is lit.  Typically, 
but not always, a second light on the Network Interface Card will be intermittently flashing, indicating 
the presence of network traffic.  If neither of these lights is lit, there is a problem with the NIC.