Elmo EDR-X1 Manuale Supplementare
EDR-X1 SAMPLE PROGRAM
§
Please make sure of the following before starting to use this software.
1. Please make sure that Java software provided by Sun Microsystems is installed
in your PC. If not, please install according to the following instructions.
i. Go to http://java.sun.com/j2se/1.4.2_04/download.html
ii. Download J2SE v 1.4.2_04 (JRE)
32-bit/64-bit for Windows/Linux/Solaris SPARC
32-bit for Solaris x86
32-bit for Solaris x86
iii. Run the install package on your PC.
NOTE: This remote program is not compatible with the Java provided by
Microsoft! This remote program is compatible only with Windows 98/2000/XP
§
Start up
1. Power on the EDR-X1, and wait until the LED is illuminated after flashing.
2. Setup the network on the EDR-X1 at the MENU screen. Check the accessibility
2. Setup the network on the EDR-X1 at the MENU screen. Check the accessibility
by pinging the EDR-X1.
3. Make sure there is recorded data in the hard disk of the EDR-X1. This program
does not work if there is no recorded data in the hard disk.
4. Double click "edr-x1prog. jar". You can make a short cut to "edr-x1prog. jar" on
your desktop. Click "AGREE" on the Remote Software Agreement screen.
5. Input the IP address of the EDR-X1, then click "REGISTER" to make the IP
address registered. If the IP address is already registered, you can skip this
article 5.
article 5.
6. Choose the IP address you need to access and click "CONNECT". If the
connection was not successfully made, an error message such as "Network
Error" or "Command Error" appears on the screen. 'Check your DVR if one of
these error message appears.
Error" or "Command Error" appears on the screen. 'Check your DVR if one of
these error message appears.
§
Features
CURRENT MODE
1-1 POWER ON MODE:
1-1 POWER ON MODE:
One of the following modes currently selected is displayed.
Normal
Auto
Power off
1-2 REWRITE MODE:
One of the following modes currently selected is displayed.
Ring off
On
Only Internal Disk