Elmo EDR-X1 Manual Suplementar

§ 

1.  Please make sure that Java software provided by Sun Microsystems is installed 

in your PC.  If not, please install according to the following instructions. 

 

i.  Go to http://java.sun.com/j2se/1.4.2_04/download.html 

ii.  Download J2SE v 1.4.2_04 (JRE) 

    32-bit/64-bit for Windows/Linux/Solaris SPARC 
    32-bit for Solaris x86 

iii.  Run the install package on your PC. 

 
NOTE:  This remote program is not compatible with the Java provided by 
Microsoft!   This remote program is compatible only with Windows 98/2000/XP  
 

§ 

 

 

1.  Power on the EDR-X1, and wait until the LED is illuminated after flashing. 
2.  Setup the network on the EDR-X1 at the MENU screen.  Check the accessibility 

by pinging the EDR-X1. 

3.  Make sure there is recorded data in the hard disk of the EDR-X1.  This program 

does not work if there is no recorded data in the hard disk. 

4.  Double click "edr-x1prog. jar".  You can make a short cut to "edr-x1prog. jar" on 

your desktop.  Click "AGREE" on the Remote Software Agreement screen. 

5.  Input the IP address of the EDR-X1, then click "REGISTER" to make the IP 

address registered.  If the IP address is already registered, you can skip this 
article 5. 

6.  Choose the IP address you need to access and click "CONNECT".  If the 

connection was not successfully made, an error message such as "Network 
Error" or "Command Error" appears on the screen.  'Check your DVR if one of 
these error message appears. 

§ 

 

 

CURRENT MODE 
 
1-1 POWER ON MODE: 

One of the following modes currently selected is displayed. 
 
 

 

Normal 

 

 

Auto 

 

 

Power off 

 

1-2 REWRITE MODE: 

One of the following modes currently selected is displayed. 
 
 

 

Ring off 

 

 

On 

 

 

Only Internal Disk